Miette Hot Pool Rehab - Jasper National Park

5P468-23-0224/A - Miette Hot Pool Rehab - Jasper National Park BIDS RECEIVED BY FAX AND EMAIL WILL BE ACCEPTED AS OFFICIAL. PARKS CANADA IS NOT CURRENTLY ACCEPTING BIDS VIA SAP ARIBA, YOU MUST SUBMIT YOUR BID VIA FAX OR EMAIL AS INDICATED IN THE SOLICITATION DOCUMENT. BIDS RECEIVED IN-PERSON OR BY COURIER WILL NOT BE ACCEPTED. The only acceptable email address for responses to bid solicitations is soumissionsami-bidsrpc@pc.gc.ca. Bids submitted by email directly to the Contracting Authority or to any email address other than soumissionsami-bidsrpc@pc.gc.ca will not be accepted. The only acceptable facsimile for responses to bid solicitations is 1-855-983-1808. The maximum email file size that Parks Canada is capable of receiving is 15 megabytes. The Bidder is responsible for any failure attributable to the transmission or receipt of the emailed bid due to file size. The Bidder should be cognisant of the size of the email as a whole, and not only the attachments. Please take into consideration that some attachments, when sent, may be resized during the email transfer. If the email size is too large, the Bidder should send the bid in multiple emails properly labeled with the solicitation number, project name, and indicate how many emails are included (ex. 1 of 2). Emails with links to bid documents will not be accepted. Bid documents must be sent as email attachments. REQUIREMENT Parks Canada Agency (PCA) is seeking the services of a trained and certified EcoFinish installer, or a Protech Polyarmor Series installer to prepare and apply the thermoplastic coating system known as EcoFinish or Protech Polyarmor Series to the deep pool basin at the Miette Hot Springs. Eco-finish or Protech Polyarmor Series will take the place of annual pool painting. The pool dimensions are approximately 10m by 15m, depth ranges from 0.9 to 1.5m. To assist with bonding and insurance requirements, this project is estimated at a value between $100,001 > $ 250,000 Taxes extra. TWO-SUBMISSION BID This Bid shall be submitted following a “two-submission” procedure. Refer to SI04 of the Special Instructions to Bidders. PERIOD OF CONTRACT / DELIVERY DATE Contractor shall perform and complete the Work no later than April 26, 2024. OPTIONAL SITE VISIT It is recommended that the Bidder or a representative of the Bidder visit the work site. Arrangements have been made for the site visit to be held at the locked gate located on Miette Road (near Punchbowl falls, approximate coordinates latitude 53. 199133, longitude -117.920895 on, December 20th, 2023. The site visit will begin at 1:00pm MST. PPE is not required; bidders are required to have 4-wheel/all-wheel drive vehicle with winter tires. Miette Road has no cell service. Bidders should communicate with the Contracting Authority no later than December 19, 2023, at 12:00pm MST to confirm attendance and provide the name(s) of the person(s) who will attend. Bidders who do not confirm attendance, provide the name(s) of the person(s) who will attend, or who do not complete and submit the above certification as required will not be allowed access to the site. Bidders will be requested to sign an attendance sheet. No alternative appointment will be given to bidders who do not attend or do not send a representative. Bidders who do not participate in the visit will not be precluded from submitting a bid. Any clarifications or changes to the bid solicitation resulting from the site visit will be included as an amendment to the bid solicitation. ENQUIRIES All enquiries of a technical and contractual nature are to be submitted to the Contracting Authority. Enquiries regarding this solicitation must be submitted in writing and should be received no later than five (5) business days prior to the date set for solicitation closing to allow sufficient time to provide a response. Enquiries received after that time may result in an answer NOT being provided. INFORMATION National Parks Regulations require that all work is to be performed in accordance with the ordinances, laws, rules and regulations set out in the National Park Act. Bidders that consider themselves qualified to provide this Work and intend to submit bids on this project should obtain documents from the Government Electronic Tendering Service through the Government of Canada tendering service at http://canadabuys.canada.ca/en/tender-opportunities. Addenda, when issued, will be available from the Government of Canada tendering service. Bidders that elect to base their bids on documents obtained from other sources do so at their own risk. Late submissions will not be considered. The Crown retains the right to negotiate with suppliers on any procurement. Documents may be submitted in either official language of Canada. Parks Canada has made every effort to provide equivalent documents in both official languages, however, if you find any discrepancies between the English and French documents, please notify the contract officer listed in this opportunity as soon as possible so that we can rectify the situation.